Clip On Earrings - Adjust with Comfort Key
Grip prong or edge of earring clip with the key. If clip is too tight - twist key back. If too loose - twist key down
(As per instructions)
Pin Stems - Tighten
-
I use a pair of small bent-nose pliers. Grip the end where the pin stem attaches on both sides and squeeze gently but firmly. Then try moving the stem; repeat until you have the movement easy but firm. You can do the same thing with safety catches that rotate too loosely and won't hold the pin stem. But squeeze GENTLY or you end up with a dented catch that may or may not turn at all. Holly (Hollihox Vintage Treasures)
-
I have an additional idea about the procedure of tightening pin stems. Here's a trick to prevent pin stem dents -- put a roll of paper towels around the outside of the end where the pin stem attaches, or wind a roll of tape around the individual prongs of the pliers. This can prevent damaging the metal. As you said, do it gently -- or you could damage it -- and test as you go, otherwise you could crimp it too tightly, and it is more difficult to loosen again without damaging it than it is to tighten. Francesca (Shimerees)
|
